It would be so much cheaper and less confusing if you were to just buy some original 500hz/800hz Altec crossovers.
Even better Altec solution would be the N1201-8A or model 19 crossovers.Then you only need one mono amp per side. Plus a stereo preamp. Or one integrated amp total.
Especially since you don't seem to know much about loudspeakers.
Sell the electronic crossovers, you might even come out ahead in the $ department.
Ron
Enjoying Altec Speakers since 1972
use two stereo amplifiers , for high and low ...is it not recommended ? or it's just for saving money ?
which it the best option for a crossover ?
I have discovered this website:
Hasling Audio Systems Denmark
passive crossover ?
Are those black? I love black.
Thanks for schematic:
I'm going to try it myself.
where can I get the Accessoires ?
Parts Express & Madisound... You will need to use both places as you can't get all components from one place.Like the 3.9 ohm resistors you have to get from Madisound Audio.
Madisound Speaker Components: distributor of loudspeaker drivers and parts for speaker builders.
http://www.parts-express.com/wizards...itors&x=19&y=6
He's in Spain- maybe
Europe Audio ? Cross-over parts
Your neighbors called. They like your music.
Posting Permissions
Bookmarks